Dishwasher hookups and fixture repairs: sinks, toilets, tubs and showers handled in one visit
Most fixture calls come down to one choice: fix the part that is failing, or replace the whole fixture because the repair will not last. The pages below sort the common cases by what you can see and hear, so you can describe the problem clearly and know what a visit should include.
- Licensed and insured plumbers
- Same-day service when available
- 24/7 emergency dispatch

Bathroom sink and vanity: what the symptom points to
A bathroom sink that drips, drains slowly or leaves a wet cabinet floor usually has one of four causes: a worn faucet cartridge, a loose or cracked supply line, a pop-up stopper assembly that has loosened, or a trap that has partly clogged. Open the vanity doors and run the water with a flashlight and a dry paper towel. Wherever the towel gets wet first is where the repair starts.
Vanity work often becomes a replacement when the cabinet floor is swollen from a slow leak, because a new faucet on a soft base only hides the damage. A plumber can replace the faucet, supply lines, stopper and trap together, and can swap an old S-trap for a P-trap while the vanity is open, which keeps the new parts from loading an old connection. If the vanity itself is being swapped, the shutoff valves and drain stub are the time to upgrade, since the wall is already open.

Toilet repair: running, weak flush, rocking or leaking at the base
A toilet that runs after flushing is nearly always the flapper, the fill valve or the float setting. A weak flush points to mineral buildup at the rim jets, a partly blocked trap or a low water level in the tank. A toilet that rocks or weeps at the floor has lost its seal, and the wax ring or the closet bolts are the usual suspects.
| What you notice | Common cause | Typical fix |
|---|---|---|
| Tank refills every few minutes | Flapper not sealing | New flapper and chain adjustment |
| Hissing after the flush ends | Worn fill valve | New fill valve and float set |
| Water at the base of the bowl | Failed wax ring or loose bolts | Reset toilet on a new wax ring |
| Bowl empties slowly or gurgles | Partial clog in trap or branch drain | Auger, then check other drains |
| Wet floor behind the tank | Supply line or angle valve leaking | New supply line or valve |
If the toilet has been pulled and reset, ask the plumber to confirm the flange sits level with the finished floor and that the closet bolts are snug without cracking the porcelain. A reset done on a damaged flange will leak again within months.
A fixture that will not stop running?
Describe the sound and the spot. Dispatch can say whether it needs a part, a reset or a replacement.
Call (984) 237-6514Faucet repair and replacement for kitchen sinks and bathrooms
Single-handle faucets fail at the cartridge, and two-handle faucets fail at the stems and seats. Both are repairable when parts exist, but older or discontinued models are often less trouble to replace than to rebuild. A kitchen faucet with a pull-down sprayer adds a hose and weight, so the replacement should come with new supply lines rather than reused ones.
Kitchen sinks bring two extras: a basket strainer that leaks at the rim, and a disposal or dishwasher that shares the drain. If the disposal is the real issue, disposal replacement page covers jams, leaks and replacement. When the sink is being replaced, the plumber disconnects supply, drain and any sprayer, sets the new sink and reconnects everything so the cabinet stays dry.

Toilet installation and replacement: what a clean swap includes
A replacement toilet starts with measurements. The distance from the wall to the center of the floor flange, usually called the rough-in, decides which models fit. A plumber shuts off the supply, empties the tank and bowl, lifts the old unit, scrapes the old wax and inspects the flange before anything new goes down.
The new toilet sets on a fresh wax ring or an approved gasket, gets snug bolts, and receives a new supply line and angle valve. After setting, the plumber flushes several times, checks for seepage at the base and caulks only where the owner wants it. Ask whether the old unit will be hauled away.
- Measure before buying. Check the rough-in distance and the space beside and in front of the toilet.
- Choose height and bowl shape. Taller seats and elongated bowls suit many adults, round bowls save floor space.
- Have the supply valve replaced. An old angle valve that sticks or weeps should be swapped while the toilet is off.
- Test under use. Flush at least three times and watch the base for moisture.
Ready to swap the toilet or faucet?
Give the fixture type and the rough-in, and a plumber at (984) 237-6514 can plan the visit.
Call (984) 237-6514Tub and shower: valves, heads and leaks behind the wall
A shower that drips from the head after the water is off usually has a worn cartridge or seat. A tub spout that sprays from the diverter, a handle that will not hold temperature, or a stain on the ceiling below are signs the valve needs work. Replacing a valve cartridge is a short job, but replacing the valve body means opening the wall.
Behind-the-wall leaks deserve attention. If a ceiling stain appears below a bathroom or the tub floor feels soft, stop using the fixture and have the source found before tile is replaced. Leak detection and repair page explains how hidden leaks are located without tearing out more than needed.

Dishwasher, washer and ice maker hookups, plus remodel rough-in
A dishwasher needs a hot supply with a shutoff, a drain connection that cannot siphon back into the machine, and a power connection from an electrician or the existing outlet. A plumber handles the water and drain side and follows the manufacturer's installation sheet for the drain loop or air gap. Washers need two supplies and a standpipe, and ice makers need a small supply line with its own valve.
Remodels and new construction are the other large category. When a kitchen or bath is opened up or framed new, the plumber sets the rough-in for the new layout, pressure tests the new runs before drywall, and leaves clear shutoffs at each fixture. A short note on the quote about who patches the wall and who orders the fixtures prevents delays later.
Smaller items belong on the same visit: outdoor hose bibs, bidet seats, and specialty fixtures such as pot fillers or utility sinks. Larger specialty jobs, such as an ADU bath, a wet bar, a laundry room, a tub-to-shower conversion or a moved toilet, start with the same rough-in plan and a written scope. Mention them when you call so the plumber arrives with the right parts.
Can a toilet be reset with a new wax ring and angle valve?
Yes. Resetting means lifting the toilet, replacing the wax ring and, if needed, the angle valve and supply line, then setting it level on a sound flange.
Ask the plumber to check the flange height first, because a flange sunk below the floor can leave a gap the ring cannot close.
Can a plumber install a dishwasher or a toilet?
A plumber handles the water supply, drain and shutoff for both. For a dishwasher, the plumber also sets the drain loop or air gap, and an electrician or the existing outlet covers power.
Have the new unit on site, and tell the plumber the model so the right fittings are ready.
Why is my toilet backing up and not flushing?
One toilet that will not flush often has a clog in its own trap, which an auger clears. If more than one fixture is slow, the clog sits further along the drain.
Stop flushing, keep the lid down and avoid chemical cleaners, which can splash and damage the finish.
What does a main drain backup look like?
Water rising around a floor drain, gurgling toilets, or damp baseboards on the lowest level are signs the main line is blocked. A blockage between the house and the City main is the owner's to clear, according to the City.
Stop running water everywhere and call a plumber to clear the line and camera it.
Get the fixture working again
The phone is answered day and night, and a visit can be booked on the call.
Call (984) 237-6514- Licensed and insured plumbers
- Same-day service when available
- 24/7 emergency dispatch

